This is the installation method for interior floor tiles (secondary cement products).
Applicable substrate: Plywood (There are various methods for installing interior floors, but we will introduce the method using interior floor adhesive.)
1. Surface preparation
Applicable base: Plywood (There are various installation methods for interior floors, but here we will introduce the installation method using interior floor adhesive.
2. Paste
Arrange the tiles temporarily and then install them while making sure to minimize unevenness.
Apply interior floor adhesive to the base and the back of the tile and press firmly. Be careful not to create any cavities on the back side. Check the area being worked on during the process, and if there are any large uneven areas, remove the product and apply interior floor adhesive to the back of the product to adjust the unevenness as you work. After installation, check that the unevenness has been adjusted.
3.目地入れ
Fill the joints with mortar. Fill the joints up to the surface of the product (to prevent tripping).
Wipe off any grout stains on the surface with a sponge that has been soaked in water and wrung out. The stains will become harder to remove over time.
After completion, inspect the area and refill any gaps that are not completely filled.
4.Curing
Be sure to cover the area thoroughly with a sheet or similar.
Do not stand on or place objects on the construction area during construction.
*It will take about a week to cure until the final hardening. Please try to keep the area as well ventilated as possible until hardening is complete.
5. Cleaning
After completing the preparation, thoroughly brush off any dust from the product surface and joints.
◎As this is a secondary cement product, acid washing is strictly prohibited.